FixVault
Home › Hummer › 2007 › H3 Standard › Repair and Diagnosis › Brakes › Traction Control › Antilock Brake System With TCS & VSES › Repair Instructions › Rear Wheel Speed Sensor Ring Replacement › Installation Procedure

Installation Procedure

    Fig 1: Installing Wheel Speed Sensor Ring
    GM885621Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel speed sensor ring using the J 45860  (1) and the J 8092  (2).
  2. Drive the wheel speed sensor ring into the axle housing until the tool bottoms against the tube.
    3. Fig 2: Installing The Axle Shaft Bearing
    GM695758Courtesy of GENERAL MOTORS CORP.
  3. Install the axle shaft bearing using the J 23690  (1) and the J 8092  (2).
  4. Drive the axle shaft bearing into the axle housing until the tool bottoms against the tube.
    5. Fig 3: Installing Axle Shaft Seal
    GM885624Courtesy of GENERAL MOTORS CORP.
  5. Install the axle shaft seal using the J 21128  .
  6. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
  7. Install the axle shaft. Refer to Rear Axle Shaft Replacement .
  8. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
  9. Install the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement .
  10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  11. Fill the rear axle. Refer to Rear Axle Lubricant Replacement .
  12. Lower the vehicle.
About FixVault