FixVault
Home › Hummer › 2008 › H2 4D Utility Pickup › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 6.2L - Introduction (2 Of 2) › Repair Instructions › Camshaft Position Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Camshaft Position (CMP) Sensor & Bolt
    GM260128Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the CMP sensor.
  2. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  3. Connect the CMP sensor electrical connector.
  4. Install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement (6.0L (LQ4)) .
About FixVault