Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inflatable Restraint I/P Module

Courtesy of GENERAL MOTORS CORP.

Install the inflatable restraint I/P module (1) to the mounting bracket through the front of the instrument panel.

NOTE: Refer to Fastener Notice .

Install the fasteners (2) to the inflatable restraint I/P module.
Tighten: Tighten the fasteners to 10 N.m (89 lb in).
Enable the SIR system. Refer to SIR Disabling and Enabling .
Install the yellow connector to the I/P.
Install the trim panel to the substraight. Refer to Instrument Panel Accessory Trim Plate Replacement - Right Side .