FixVault
Home › Hummer › 2008 › H2 4D Utility Pickup › Repair and Diagnosis › External Pages › Different car › Section 20 (Vehicle Access) › Repair Instructions › Midgate Latch Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2007 Hummer H2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the electrical connector to the midgate latch.
    2. Fig 1: Midgate Latch To The Midgate Structure
    GM1412512Courtesy of GENERAL MOTORS CORP.
  2. Position the midgate latch to the midgate structure.
    3. NOTE: Refer to Fastener Notice .
  3. Install the screws retaining the midgate latch to the midgate structure.

    Tighten:  Tighten the midgate latch screws to 10 N.m (89 lb in).

    4. Fig 2: Midgate Window
    GM1412518Courtesy of GENERAL MOTORS CORP.
  4. Install the midgate window run channel. Refer to Midgate Window Channel Replacement .
  5. Install the midgate window. Refer to Midgate Window Replacement .
    6. Fig 3: Separating Inner Midgate
    GM1412513Courtesy of GENERAL MOTORS CORP.
  6. Install the midgate inner panel. Refer to Midgate Inner Panel Replacement .
  7. Inspect the midgate window and latches for proper operation.
About FixVault