FixVault
Home › Hummer › 2008 › H3 Alpha › Repair and Diagnosis › External Pages › Different car › Section 106 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Sensing and Diagnostic Module Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not strike or jolt the inflatable restraint sensing and diagnostic module (SDM). Before applying power to the SDM, make sure that it is securely fastened with the arrow facing toward the front of the vehicle. Failure to observe the correct installation procedure could cause SIR deployment, personal injury, or unnecessary SIR system repairs.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling .
  2. Remove the console. Refer to Console Replacement .
  3. Remove the inflatable restraint sensing and diagnostic module nuts.
  4. Remove the inflatable restraint sensing and diagnostic module wire harness connector.
    5. Fig 1: Locating Inflatable Restraint Sensing & Diagnostic Module
    GM1208028Courtesy of GENERAL MOTORS CORP.
  5. Remove the inflatable restraint sensing and diagnostic module.
About FixVault