Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Side Impact Sensor Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector.

NOTE: Refer to Fastener Notice .

Position the sensor to the vehicle and install the sensor fasteners.
Tighten: Tighten the fasteners to 9 N.m (80 lb in).
Install the door trim panel. Refer to Front Side Door Trim Panel Replacement .
Enable the roof rail SIR system. Refer to SIR Disabling and Enabling .