FixVault
Home › Hummer › 2008 › H3 Alpha › Repair and Diagnosis › External Pages › Different car › Section 107 (Instrument Panel Trim And Console Trim) › Repair Instructions › Console Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Electrical Connectors And Console
    GM1207909Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not let the console contact the shifter handle or bezel.
  1. Connect the electrical connectors and install the console.
    2. Fig 2: View Of Pen Tray
    GM1207906Courtesy of GENERAL MOTORS CORP.
  2. Install the pen tray.
    3. Fig 3: View Of Rear Console Bolts
    GM1207907Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the rear console bolts.

    Tighten:  Tighten the bolts to 1 N.m (10 lb in).

  4. Install the front console screws.

    Tighten:  Tighten the bolts to 1 N.m (10 lb in).

    5. Fig 4: View Of Front Console Screws
    GM1207902Courtesy of GENERAL MOTORS CORP.
  5. Install the front console screw cover.
  6. Install the left console trim panel. Refer to Front Floor Console Side Trim Panel Replacement - Left Side .
  7. Install the right console trim panel. Refer to Front Floor Console Side Trim Panel Replacement - Right Side .
About FixVault