FixVault
Home › Hummer › 2008 › H3 Alpha › Repair and Diagnosis › External Pages › Different car › Section 134 (Wiper System & Washer System) › Repair Instructions › Windshield Washer Solvent Container Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Solvent Container Washer Hose
    GM1331351Courtesy of GENERAL MOTORS CORP.
  1. Open the hood.
  2. Disconnect the solvent container washer hose from the windshield washer hose.
  3. Drain the washer solvent from the washer solvent container.
  4. Remove the front fender liner. Refer to Front Fender Liner Replacement .
    5. Fig 2: View Of Washer Level Sensor Electrical Connector
    GM1202069Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the washer level sensor electrical connector.
  6. Disconnect the washer pump electrical connector.
  7. Remove the washer solvent container nuts.
  8. Remove the washer solvent container from the left frame rail.
  9. Remove and transfer the following components from the washer solvent container:
About FixVault