FixVault
Home › Hummer › 2008 › H3 Alpha › Repair and Diagnosis › External Pages › Different car › Section 134 (Wiper System & Washer System) › Repair Instructions › Wiper Motor Module Support Bracket Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Wiper Motor Module Support Bracket Screws
    GM1206999Courtesy of GENERAL MOTORS CORP.
  1. Position the wiper motor module support bracket to the wiper motor.
    2. NOTE: Refer to Fastener Notice .
  2. Install the wiper motor module support bracket screws.

    Tighten:  Tighten the screws to 5.5 N.m (49 lb in).

  3. Install the wiper drive system module. Refer to Windshield Wiper System Module Replacement .
  4. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  5. Cycle the wiper drive system. Turn off the wiper drive system at the park position to ensure proper positioning of the wiper arms upon installation.
  6. Install the wiper arms. Refer to Windshield Wiper Arm Replacement .
About FixVault