Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Recirculation Actuator Screws

Courtesy of GENERAL MOTORS CORP.

Install the recirculation actuator.

NOTE: Refer to Fastener Notice .

Install the recirculation actuator screws (1).
Tighten: Tighten the screws to 1 N.m (9 lb in).

Fig 2: View Of Recirculation Actuator Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connector to the recirculation actuator.
Install the air inlet assembly. Refer to Air Inlet Assembly Replacement .