FixVault
Home › Hummer › 2008 › H3 Alpha › Repair and Diagnosis › External Pages › Different car › Section 230 (Engine Controls And Fuel - 4.4L - Introduction) › Repair Instructions › Primary Fuel Level Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Gasoline/Gasoline Vapors Caution .
  1. Remove the fuel tank. Refer to Fuel Tank Replacement .
  2. Remove the primary fuel tank module. Refer to Primary Fuel Tank Module Replacement .
    3. Fig 1: View Of Primary Fuel Level Sensor Electrical Connector
    GM820628Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the fuel level sensor electrical connector (1) from the module.
    4. Fig 2: View Of Fuel Level Sensor & Locking Tab
    GM820629Courtesy of GENERAL MOTORS CORP.
  4. Complete the following in order to remove the fuel level sensor (1) from the module assembly:
    1. Pull the locking tab (2) away from the sensor (1).
    2. Slide the sensor (1) away from the module assembly.
About FixVault