FixVault
Home › Hummer › 2008 › H3 Alpha › Repair and Diagnosis › External Pages › Different car › Section 409 (Suspension Control System - Suspension Leveling) › Repair Instructions › Automatic Level Control Sensor and Bracket Replacement (Front) › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Ride Sensor
    GM1371680Courtesy of GENERAL MOTORS CORP.
  1. Position the sensor to the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the front ride sensor retaining nut and tighten to 9 N.m (80 lb in).
    3. Fig 2: View Of Front Ride Sensor Link
    GM1371682Courtesy of GENERAL MOTORS CORP.
  3. Connect the front ride sensor link to the upper control arm ball stud.
  4. Connect the front ride sensor harness connector.
  5. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
About FixVault