FixVault
Home › Hummer › 2008 › H3 Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 10 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Passenger Presence System Replacement - Front › Installation Procedures

Installation Procedures

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Cushion Frame Bladder Retainers
    GM811858Courtesy of GENERAL MOTORS CORP.
  1. Install the inflatable restraint passenger presence system to the seat.
  2. Install the push-in retainers (1) that hold the bladder to the seat cushion frame.
    3. Fig 2: View Of Electronic Control Unit & Pressure Switch
    GM811855Courtesy of GENERAL MOTORS CORP.
  3. Install the pressure sensor (2) to the bottom of the passenger seat cushion frame.
    4. NOTE: Refer to Fastener Notice .
  4. Install the bolts that retain the ECU (1) to the bottom the passenger seat cushion frame.

    Tighten:  Tighten the bolts to 2 N.m (18 lb in).

  5. Connect the electrical connectors.
  6. Install the seat cushion trim cover and pad.
  7. Re-zero the inflatable restraint passenger presence system. Refer to Control Module References .
About FixVault