Installation Procedure
WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
- Install the HVAC control module wire harness connectors.
- Install the HVAC control module.
- Tighten the HVAC control module screws.
Tighten: Tighten the screws to 2.5 N.m (22 lb in).
- Install the I/P center trim panel. Refer to Instrument Panel Center Trim Panel Replacement .
- Start the engine and let run for one minute.
- Refer to Control Module References for programming and setup information.
IMPORTANT:
The key should be in the OFF position when connecting the electrical connectors to ensure proper calibration.
NOTE:
Refer to Fastener Notice
.
IMPORTANT:
Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating. If interrupted improper HVAC performance will result.