FixVault
Home › Hummer › 2008 › H3 Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 133 (HVAC System - Automatic) › Repair Instructions › Mode Actuator Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Mode Actuator Screws
    GM1203571Courtesy of GENERAL MOTORS CORP.
  1. Install the mode actuator.
    2. NOTE: Refer to Fastener Notice .
  2. Install the mode actuator screws.

    Tighten:  Tighten the screws to 1.5 N.m (13 lb in).

  3. Install the mode actuator wire harness connector.
  4. Close I/P compartment door. Refer to Instrument Panel Compartment Replacement .
  5. Install the fuse labeled HVAC CTRL (BATT).
About FixVault