FixVault
Home › Hummer › 2008 › H3 Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 154 (Wheel Alignment System) › Repair Instructions › Rear Camber Adjustment

Rear Camber Adjustment

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Inner Lower Control Arm Cam Bolt Nuts
    GM1237902Courtesy of GENERAL MOTORS CORP.
  1. Loosen the inner lower control arm cam bolt nuts.
  2. Rotate the cam bolts to the required camber specification setting. Refer to Wheel Alignment Measurement .
    3. NOTE: Refer to Fastener Notice .
  3. Maintain the camber setting while tightening the cam bolt nuts.

    Tighten:  Tighten the inner lower control arm (front) bolt nut to 110 N.m (81 lb ft).

    4. IMPORTANT: Check the toe setting AFTER changing camber or caster.
  4. Check the camber setting after tightening.
  5. Adjust the camber setting if necessary.
About FixVault