FixVault
Home › Hummer › 2008 › H3 Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 165 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Side Impact Module Wiring Harness Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Inflatable Restraint Side Impact Module Wiring Harness
    GM513378Courtesy of GENERAL MOTORS CORP.
  1. Install the new side impact module wiring harness (3) to the seat (1).
  2. Install the retaining clips that fasten the side impact module wiring harness (3) to the seat (1).
  3. Install the side impact module (2) to the seat (1). Refer to Inflatable Restraint Side Impact Module Replacement - Front .
  4. Install the seat back panel.
  5. Enable the SIR system. Refer to SIR Disabling and Enabling .
About FixVault