FixVault
Home › Hummer › 2008 › H3 Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 199 (Anti-Lock Brake System, Traction Control System & Stability Control System) › Repair Instructions › Brake Fluid Pressure Sensor Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Place the ignition switch into OFF position.
  2. Remove the RH front compartment sight shield. Refer to Front Compartment Sight Shields Replacement .
  3. Thoroughly clean the area around the brake pressure modulator (BPMV) of all dirt and debris.
    4. Fig 1: View Of Brake Fluid Pressure Sensor Electrical Connector
    GM1906574Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the brake fluid pressure sensor electrical connector.
  5. Remove the brake fluid pressure sensor (1).
About FixVault