Installation Procedure
WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
- Slide the mirror downward onto the windshield support button.
- Install the set screw (3).
Tighten: Tighten the set screw to 2 N.m (18 lb in).
- Connect the electrical connector (1), if removed.
- Pull the mirror downward and install the electrical harness cover (2).
- Reposition the mirror (4).
- Refer to Control Module References for replacement and setup information.
NOTE:
Refer to Fastener Notice
.