FixVault
Home › Hummer › 2008 › H3 Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 32 (Programming And Setup - All Systems) › Repair Instructions › Body Control Module Programming and Setup › Programming the BCM

Programming the BCM

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: After the procedure is completed, the personalization settings of the BCM are set to a default setting. Inform the customer that the personalization must be set again.

This vehicle uses Service Programming System (SPS) and Tech 2 pass-thru method of programming. Refer to Service Programming System (SPS)  for more information.

  1. Connect the scan tool to the vehicle in the pass-thru arrangement.
  2. Ignition ON, engine OFF.
  3. On the Techline Terminal, select Service Programming System and follow the Techline Terminal on-screen instructions.
About FixVault