FixVault
Home › Hummer › 2008 › H3 Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 45 (Power Steering System) › Repair Instructions › Power Steering Pump Bracket Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Power Steering Pump Bracket
    GM1201382Courtesy of GENERAL MOTORS CORP.
  1. Install the power steering pump bracket.
    2. NOTE: Refer to Fastener Notice .
  2. Install the power steering pump bracket mounting bolts.

    Tighten:  Tighten the power steering pump mounting bolts to 50 N.m (37 lb ft).

  3. Install the drive belt tensioner. Refer to Drive Belt Tensioner Replacement for the 2.9L engine or Drive Belt Tensioner Removal for the 3.7L engine.
  4. install the power steering pump. Refer to Power Steering Pump Replacement .
About FixVault