FixVault
Home › Hummer › 2008 › H3 Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 45 (Power Steering System) › Repair Instructions › Power Steering Pump Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement for the 2.9L engine or Air Cleaner Assembly Replacement for the 3.7L engine.
  2. Remove the drive belt. Refer to Drive Belt Replacement for the 2.9L engine or Drive Belt Replacement for the 3.7L engine.
  3. Remove the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement .
  4. Disconnect the oil pressure sensor harness clip from the pump body.
  5. Install a drain pan under the vehicle.
    6. Fig 1: View Of Power Steering Pressure Hoses
    GM1207233Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the power steering pressure hoses from the power steering pump.
    7. Fig 2: View Of Power Steering Pump & Mounting Bolts
    GM1201379Courtesy of GENERAL MOTORS CORP.
  7. Remove the power steering pump mounting bolts.
  8. Remove the power steering pump.
About FixVault