FixVault
Home › Hummer › 2008 › H3 Base, Automatic › Repair and Diagnosis › External Pages › Different car › Section 93 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Side Impact Module Wiring Harness Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Side Impact Module Wiring Harness
    GM1506504Courtesy of GENERAL MOTORS CORP.
  1. Install the new side impact module wiring harness (1) to the seat.
  2. Install the retaining clips that fasten the side impact module wiring harness (1) to the seat.
  3. Install the side impact module to the seat. Refer to Inflatable Restraint Side Impact Module Replacement - Front .
  4. Enable the SIR system. Refer to SIR Disabling and Enabling .
About FixVault