FixVault
Home › Hummer › 2008 › H3 Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 10 (Supplemental Inflatable Restraint System) › Repair Instructions › Inflatable Restraint Steering Wheel Module Coil Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: The inflatable restraint steering wheel module coil and the multifunction turn signal switch are serviced as an assembly.
    CAUTION: Refer to SIR Caution .
  1. Disable the supplemental inflatable restraint (SIR) system. Refer to SIR Disabling and Enabling .
  2. Remove the steering wheel. Refer to Steering Wheel Replacement .
  3. Remove the steering column trim covers. Refer to Steering Column Trim Covers Replacement .
    4. Fig 1: View Of Wire Harness Straps & Assembly
    GM1488252Courtesy of GENERAL MOTORS CORP.
  4. Remove the wire harness straps from the wire harness assembly.
  5. Disconnect any electrical connectors as needed.
    6. Fig 2: View Of Multifunction Switch/SIR Coil Assembly
    GM1488282Courtesy of GENERAL MOTORS CORP.
  6. Remove the inflatable restraint steering wheel module coil bolts.
  7. Slide the inflatable restraint steering wheel module coil off of the steering column. Discard the inflatable restraint steering wheel module coil, if replacing.
About FixVault