Power Steering Pump Replacement

WARNING: This page is about a different car, the 2008 Chevrolet Malibu Classic. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Identifying Power Steering Pump Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
Preliminary Procedures Remove the intake manifold Cover. Refer to Intake Manifold Cover Replacement . Remove the drive belt. Refer to Drive Belt Replacement . Remove the drive belt idler pulley. Refer to Drive Belt Idler Pulley Replacement . Remove the air cleaner assembly. Refer to Air Cleaner Assembly Replacement . Remove the engine mount strut. Refer to Engine Mount Strut Replacement . Remove the power steering pump pulley. Refer to Power Steering Pump Pulley Replacement .
1	Engine Lift Bracket Bolt (Qty: 3) NOTE: Refer to Fastener Notice . Tighten: 50 N.m (37 lb ft)
2	Engine Lift Bracket
3	Power Steering Gear Inlet Pipe/Hose Tip: Use an appropriate tool to remove the power steering fluid from the reservoir before removing the hoses from the pump. Use a new O-ring seal for installation. Tighten: 27 N.m (20 lb ft)
4	Power Steering Reservoir Inlet Pipe/Hose Tip: Compress the clamp and to disconnect the return hose from the power steering reservoir.
5	Power Steering Pump Bolt (Qty: 3) Tighten: 25 N.m (18 lb ft)
6	Power Steering Pump Tip: After installation, fill and bleed the power steering system. Refer to Power Steering System Bleeding .