FixVault
Home › Hummer › 2008 › H3 Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 368 (Wiper System And Washer System) › Repair Instructions › Windshield Wiper Transmission Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Pivot Arms & Drive Links
    GM781424Courtesy of GENERAL MOTORS CORP.
  1. Position the transmission drive links (4) to the pivot arms (3,5).
    2. Fig 2: View Of Special Tool J39529 And Wiper Motor Crank Arm
    GM306515Courtesy of GENERAL MOTORS CORP.
  2. Install the drive links onto the wiper motor crank arm and the wiper transmission drive shafts with the J-39529:  installer.
    3. Fig 3: View Of Windshield Wiper Motor Components
    GM776830Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector (4) to the motor.
  4. Position the transmission (2) to the fender flange pin.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the bolts (3,5) and tighten to 10 N.m (89 lb in).
    6. Fig 4: View Of Wiper Arm Components
    GM776832Courtesy of GENERAL MOTORS CORP.
  6. Install the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
  7. Install the wiper arms (1,4). Refer to Windshield Wiper Arm Replacement .
  8. Operate the wipers and check for proper operation.
About FixVault