FixVault
Home › Hummer › 2008 › H3 Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 455 (Supplemental Inflatable Restraint System) › Repair Instructions › Driver or Passenger Seat Side Inflatable Restraint Module Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install a new inflatable restraint side impact module bracket.
    2. WARNING: Following the deployment of a side impact air bag, replace the inflator module bracket to the air bag. Failure to do so may cause future personal injury.
    CAUTION: Refer to Fastener Caution .
  2. Install the 2 bracket mounting bolts to the module and tighten to 9 N.m (80 lb in).
    3. Fig 1: Inflatable Restraint Side Impact Module Electrical Connector
    GM792283Courtesy of GENERAL MOTORS CORP.
  3. Connect the electrical connector (1) to the inflatable restraint side impact module.
  4. Install the CPA to the module electrical connector.
  5. Install the module to the seat.
    6. Fig 2: Inflatable Restraint Side Impact Module Bracket Bolts
    GM792279Courtesy of GENERAL MOTORS CORP.
  6. Install the 2 bolts (1) to the inflatable restraint side impact module and tighten to 9 N.m (80 lb in).
  7. Install the seat back panel. Refer to Driver or Passenger Seat Back Cushion Finish Panel Replacement .
  8. Enable the SIR system. Refer to SIR Disabling and Enabling .
  9. Fully deploy the module before disposal. If the module was replaced under warranty, fully deploy and dispose of the module after the required retention period. Refer to Inflatable Restraint Module Handling and Scrapping .
About FixVault