FixVault
Home › Hummer › 2008 › H3 Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 457 (Lighting System) › Repair Instructions › Headlamp Leveling Front Suspension Height Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 Cadillac STS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ball & Socket
    GM802716Courtesy of GENERAL MOTORS CORP.
  1. Position the sensor to the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the bolt (2) to secure the sensor to the vehicle and tighten to 9 N.m (80 lb in).
  3. Install the ball and socket (1) to the sensor.
    4. Fig 2: Headlamp Leveling Sensor Electrical Connector
    GM802719Courtesy of GENERAL MOTORS CORP.
  4. Connect the electrical connector (1) to the sensor.
  5. Install the right tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  6. Lower the vehicle.
About FixVault