FixVault
Home › Hummer › 2008 › H3 Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 50 (Cruise Control System) › Diagnostic Information and Procedures › DTC P0568 › Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2008 Isuzu i-370, 2008 Isuzu i-290, 2008 GMC Canyon, and 2008 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the steering column harness connector X204.
  2. Remove terminal B8 from the body side of connector X204. Reconnect the connector.
  3. Ignition ON, verify that the scan tool Cruise Set/Coast Switch parameter displays Off or Inactive.
    • If the scan tool parameter reads On, Active or Invalid, test the cruise control switch signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  4. If all circuits test normal, test or replace the cruise control switch assembly.
About FixVault