FixVault
Home › Hummer › 2008 › H3 Base, Standard › Repair and Diagnosis › Transmission › Manual Transmission › Repair Instructions - Off Vehicle › Shift Control Housing Disassemble

Shift Control Housing Disassemble

    Fig 1: Locating Shift Control Lever Shaft Seal
    GM880926Courtesy of GENERAL MOTORS CORP.
  1. Remove the shift control lever shaft seal by holding onto the seal and hitting the end of the shift control lever with a soft-face hammer.
    2. Fig 2: Identifying Control Lever Boot
    GM880928Courtesy of GENERAL MOTORS CORP.
  2. Remove the control lever boot.
    3. Fig 3: View Of Shift Control Lever Retainer & Retaining Bolts
    GM880937Courtesy of GENERAL MOTORS CORP.
  3. Remove the shift control shaft boot from the shift control lever retainer.
  4. Remove the shift control lever retainer bolts.
  5. Remove the shift control lever retainer.
  6. Remove the control lever housing gasket.
    7. Fig 4: Identifying Shift Control Lever Assembly
    GM880940Courtesy of GENERAL MOTORS CORP.
  7. Remove the shift control lever assembly from the shift control housing.

    Do not remove the shift lever seat or bushing from the lever. The shift lever seat and bushing can only be serviced with the lever.

About FixVault