FixVault
Home › Hummer › 2009 › H2 4D Utility Pickup › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 6.2L - Introduction › Repair Instructions › Camshaft Position Sensor Replacement › Installation Procedure

Installation Procedure

    Fig 1: View Of Camshaft Position (CMP) Sensor & Bolt
    GM260128Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Install the CMP sensor.
  2. Install the CMP sensor bolt.

    Tighten:  Tighten the bolt to 25 N.m (18 lb ft).

  3. Connect the CMP sensor electrical connector.
  4. Install the engine sight shield. Refer to Upper Intake Manifold Sight Shield Replacement .
About FixVault