FixVault
Home › Hummer › 2009 › H2 4D Utility Pickup › Repair and Diagnosis › Suspension › Front Suspension › Front Suspension System › Repair Instructions › Upper Control Arm Replacement › Installation Procedure

Installation Procedure

  1. Install the upper control arm.
    2. Fig 1: View Of Upper Control Arm
    GM793281Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  2. Install the upper control arm bolts.

    Tighten:  Tighten the nuts to 190 N.m (140 lb ft).

  3. Connect the upper control arm to the steering knuckle.
  4. Install the new nut to the upper ball joint stud.

    Tighten:  Tighten the nut to 50 N.m (39 lb ft).

  5. Install the retaining bolts for the brake hose and wheel speed sensor brackets.

    Tighten:  Tighten the bolts to 9 N.m (80 lb in).

  6. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle.
  8. Verify the wheel alignment. Refer to Wheel Alignment Specifications .
About FixVault