FixVault
Home › Hummer › 2009 › H3 Alpha › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 5.3L - Introduction › Repair Instructions › Knock Sensor 2 Replacement › Removal Procedure

Removal Procedure

    Fig 1: Engine Wiring Harness Electrical Connector At Knock Sensor
    GM1899202Courtesy of GENERAL MOTORS CORP.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Disconnect the engine wiring harness electrical connector (3) from the knock sensor.
    3. Fig 2: Right Side Knock Sensor & Bolt
    GM1402140Courtesy of GENERAL MOTORS CORP.
  3. Remove the knock sensor bolt (739) and sensor (718).
About FixVault