FixVault
Home › Hummer › 2009 › H3 Base, Automatic › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Engine Controls And Fuel - 5.3L - Introduction) › Repair Instructions › Accelerator Pedal Position Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Remove/Install Accelerator Pedal Position APP Sensor
    GM1560065Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator pedal/APP sensor over the studs.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the accelerator pedal/APP sensor nuts.

    Tighten:  Tighten the nuts to 9 N.m (80 lb in).

    3. Fig 2: View Of APP Sensor
    GM1352013Courtesy of GENERAL MOTORS CORP.
  3. Connect the body wiring harness electrical connector to the APP sensor.
  4. Inspect below the pedal for binding, to ensure full range of motion.
  5. Install the knee bolster bracket. Refer to Driver Knee Bolster Bracket Replacement (Right Hand Drive) or Driver Knee Bolster Bracket Replacement (Left Hand Drive) .
About FixVault