FixVault
Home › Hummer › 2009 › H3 Base, Standard › Repair and Diagnosis › Steering › Power Steering System › Repair Instructions › Steering Linkage Outer Tie Rod Replacement › Removal Procedure

Removal Procedure

  1. Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
    2. Fig 1: View Of Outer Tie Rod Retaining Nut
    GM1207238Courtesy of GENERAL MOTORS CORP.
  2. Remove and discard the rack and pinion outer tie rod end nut.
    3. Fig 2: Removing Outer Tie Rod Assembly From Steering Knuckle
    GM643351Courtesy of GENERAL MOTORS CORP.
    CAUTION: Do not attempt to disconnect a steering linkage joint by driving a wedge between the joint and the attached part. Seal damage may result which will cause premature failure of the joint.
  3. Disconnect the rack and pinion outer tie rod end from the steering knuckle using puller J 24319-B  . See Special Tools .
    4. NOTE: Mark the location of the rack and pinion inner tie rod nut.
  4. Loosen the rack and pinion inner tie rod nut and remove the rack and pinion outer tie rod end.
  5. Discard the rack and pinion inner tie rod nut.
  6. Clean the tapered surface of the steering knuckle.
About FixVault