FixVault
Home › Hummer › 2009 › H3T Alpha › Repair and Diagnosis › External Pages › Different car › Section 117 (Battery, Charging System And Starting System) › Repair Instructions › Battery Replacement › Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to BATTERY DISCONNECT CAUTION .
    Fig 1: View Of Battery Cable Components
    GM1702504Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Open the starter solenoid cable cover at the positive battery terminal.
  3. Loosen the starter solenoid cable nut (5).
  4. Remove the starter solenoid cable from the positive battery terminal.
    5. Fig 2: View Of Front Fender Rear Upper Brace & Bolts
    GM1702811Courtesy of GENERAL MOTORS CORP.
  5. Remove the right front fender rear upper brace bolts and the brace.
    6. Fig 3: View Of Battery Hold Down Retainer & Bolt
    GM1702812Courtesy of GENERAL MOTORS CORP.
  6. Remove the battery hold down retainer bolt and the retainer.
  7. Remove the battery.
About FixVault