FixVault
Home › Hummer › 2009 › H3T Base, Automatic › Repair and Diagnosis › Electrical › Charging Systems › Battery, Charging System And Starting System › Repair Instructions › Starter Replacement (LH8) › Removal Procedure

Removal Procedure

    Fig 1: Engine Wiring Harness Electrical Connector At Knock Sensor
    GM1899202Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
  2. Remove the right front tire. Refer to Tire and Wheel Removal and Installation .
  3. Remove the engine wiring harness/positive battery cable terminal nut (4) and cable terminal (5) from the starter.
  4. Disconnect the engine wiring harness electrical connector (2) from the starter motor.
  5. Remove the front propeller shaft. Refer to Front Propeller Shaft Replacement .
    6. Fig 2: Transmission Cover Bolt
    GM1902155Courtesy of GENERAL MOTORS CORP.
  6. Remove the transmission cover bolt (1).
    7. Fig 3: View Of Starter & Bolts (4.8L, 5.3L & 6.0L)
    GM663527Courtesy of GENERAL MOTORS CORP.
  7. Remove the starter motor bolts.
    8. Fig 4: View Of Transmission Cover & Starter
    GM663489Courtesy of GENERAL MOTORS CORP.
  8. Unsnap the transmission cover from the starter.
    9. Fig 5: View Of Starter & Heat Shield
    GM663472Courtesy of GENERAL MOTORS CORP.
  9. Remove the starter heat shield, if required.
  10. Remove the starter.
About FixVault