FixVault
Home › Hummer › 2009 › H3T Base, Automatic › Repair and Diagnosis › External Pages › Different variant/trim › Section 2 (Engine Controls And Fuel - 5.3L - Introduction) › Repair Instructions › Air Cleaner Assembly Replacement › Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Engine Wiring Harness Electrical Connector
    GM1897141Courtesy of GENERAL MOTORS CORP.
  1. Remove the air cleaner outlet duct from the air cleaner. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  2. Disconnect the engine wiring harness electrical connector (1) from the mass airflow (MAF)/intake air temperature (IAT) sensor.
    3. Fig 2: Integral Air Cleaner Housing Bolts
    GM1899698Courtesy of GENERAL MOTORS CORP.
  3. Loosen the integral air cleaner housing bolts (2).
  4. Remove the air cleaner housing (1) from the vehicle.
About FixVault