FixVault
Home › Hummer › 2010 › H3 Base, Standard › Repair and Diagnosis › Engine Performance › System › Engine Controls And Fuel - 3.7L - Repair Instructions › Repair Instructions › Camshaft Position Sensor Replacement - Intake › Removal Procedure

Removal Procedure

    Fig 1: Intake CMP Sensor Engine Wiring Harness Connector
    GM1350719Courtesy of GENERAL MOTORS CORP.
  1. Disconnect the engine wiring harness electrical connector from the intake camshaft position (CMP) sensor.
    2. Fig 2: Intake Camshaft Sensor & Retaining Bolt
    GM858173Courtesy of GENERAL MOTORS CORP.
  2. Remove the intake CMP sensor retaining bolt.
  3. Remove the intake CMP sensor from the cylinder head.

    Discard the O-ring seal.

About FixVault