FixVault
Home › Hummer › 2010 › H3 Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 19 (Frame And Underbody) › Repair Instructions › Engine Protection Shield Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Rear Protection Shield
    GM1871958Courtesy of GENERAL MOTORS CORP.
  1. Install the rear shield to the vehicle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the rear shield bolts (1) and tighten to 75 N.m (55 lb ft).
  3. Install the rear shield bolts (2) and tighten to 20 N.m (15 lb ft).
    4. Fig 2: View Of Engine Front Protection Shield
    GM1871957Courtesy of GENERAL MOTORS CORP.
  4. Install the front shield to the vehicle.
  5. Install the front shield bolts (1) and tighten to 60 N.m (44 lb ft).
  6. Install the front shield bolts (2) and tighten to 20 N.m (15 lb ft).
About FixVault