FixVault
Home › Hummer › 2010 › H3 Base, Standard › Repair and Diagnosis › External Pages › Different car › Section 79 (Front Drive Axle) › Repair Instructions › Front Axle Lubricant Replacement

Front Axle Lubricant Replacement

WARNING: This page is about a different car, the 2010 GMC Canyon and 2010 Chevrolet Colorado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Ensure that the vehicle is level.
  3. Remove the engine protection shield (EPS), if equipped. Refer to Engine Protection Shield Replacement .
  4. Remove the drain plug.
  5. Drain axle fluid into a suitable container.
    6. CAUTION: Refer to Fastener Caution .
  6. Install the drain plug and tighten to 32 N.m (24 lb ft).
  7. Remove the fill plug.
  8. Fill the drive axle with the proper fluid. Refer to Fluid and Lubricant Recommendations (USA and Canada) .
  9. Inspect the fluid level. Refer to Front Axle Lubricant Level Inspection .
  10. Install the fill plug and tighten to 32 N.m (24 lb ft).
  11. Install the EPS, if equipped. Refer to Engine Protection Shield Replacement .
  12. Lower the vehicle.
About FixVault