FixVault
Home › Hummer › 2010 › H3T Alpha › Repair and Diagnosis › External Pages › Different variant/trim › Section 4 (Engine Controls And Fuel - 3.7L - Repair Instructions) › Repair Instructions › Accelerator Pedal Position Sensor Replacement › Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: Accelerator Pedal Position Sensor
    GM1560065Courtesy of GENERAL MOTORS CORP.
  1. Install the accelerator pedal/APP sensor over the studs.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the accelerator pedal/APP sensor nuts and tighten to 9 N.m (80 lb in).
    3. Fig 2: APP Sensor Electrical Connector
    GM1352013Courtesy of GENERAL MOTORS CORP.
  3. Connect the APP sensor electrical connector.
  4. Inspect below the pedal for binding, to ensure full range of motion.
About FixVault