FixVault
Home › Hummer › 2010 › H3T Base, Automatic › Repair and Diagnosis › Steering › Power Steering › Repair Instructions › Steering Linkage Inner Tie Rod Replacement › Installation Procedure

Installation Procedure

    Fig 1: Rack & Inner Tie Rod
    GM297389Courtesy of GENERAL MOTORS CORP.
  1. Clean the inner tie rod threads (2).
  2. Install the inner tie rod (3) to the rack (1).
    3. Fig 2: Tightening Inner Tie Rod
    GM297392Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Position a torque wrench and the J-34028:  wrench on the inner tie rod housing (4). Use a wrench in order to hold the rack (3) while tightening the inner tie rod (5) to 88 N.m (65 lb ft).
    4. Fig 3: Inner Tie Rod Housing Notch
    GM1646497Courtesy of GENERAL MOTORS CORP.
  4. Use a hammer and a punch in order to stake the inner tie rod housing (2) at the notch (1).
  5. Install the steering gear boot. Refer to Steering Gear Boot Replacement .
  6. Measure and adjust the front toe. Refer to Wheel Alignment - Steering Wheel Angle and/or Front Toe Adjustment .
About FixVault