Front Wiper/Washer Switch

Wiper/washer switch is incorporated within multifunction switch, mounted on steering column. Test continuity of wiper switch circuits with switch in position indicated in table. Refer to the WIPER/WASHER SWITCH CONTINUITY TEST .
Ensure continuity exists between terminals listed. Check connector and terminal cavity identification. SeeFig 1 . For terminal descriptions, see MULTIFUNCTION SWITCH TERMINAL IDENTIFICATION .

Fig 1: Multifunction Switch Connector Terminal ID

Courtesy of HYUNDAI MOTOR CO.

WIPER/WASHER SWITCH CONTINUITY TEST ⁽¹⁾

Switch Position

Terminal Numbers

Off

19 & 21

Intermittent ⁽²⁾

19 & 21; 18, ⁽²⁾ 16 & 13

Low

16 & 21

High

16 & 20

Washer

16 & 17

⁽¹⁾	Continuity should exist between terminals listed on multifunction switch connector "A".

⁽²⁾	A resistor in circuit should fluctuate resistance between terminals No. 16 and 13.