FixVault

Torque Specifications

WARNING: For updated reuse guidelines and tightening procedures of cylinder head, connecting rod and main bearing bolts, see Technical Service Bulletin (TSB) 02-20-002. Refer to CYLINDER HEAD/CONNECTING ROD/MAIN BEARING BOLT REUSE GUIDELINES & TORQUE SPECS .
TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
Camshaft Sprocket Bolt 59-74 (80-100)
Connecting Rod Cap Nut 24-26 (33-35)
Crankshaft Sprocket Bolt 103-111 (140-150)
Cylinder Head Bolt (1) 18 (25) Plus 60 Degrees, Plus An Additional 60 Degrees
Drive Plate-To-Crankshaft Bolt 96-103 (130-140)
Engine Mount
Mounting Bolt 37-48 (50-65)
Through-Bolt 66-81 (90-110)
Exhaust Manifold-To-Engine Bolt 11-15 (15-20)
Exhaust Pipe-To-Manifold Bolt 22-30 (30-40)
Flywheel-To-Crankshaft Bolt 96-103 (130-140)
Front Cover Bolt 9-11 (12-15)
Front Roll Stopper 22-30 (30-40)
Intake Manifold Bolt 11-15 (15-20)
Intake Manifold Brace Bolt 13-18 (18-25)
Main Bearing Cap Bolt 41-44 (55-60)
Oil Drain Plug 26-33 (35-45)
Oil Pressure Switch 10-11 (14-15)
Oil Pump Cover Bolt 9-11 (12-15)
Oil Pump Relief Valve Plug Cap 30-37 (40-50)
Oil Screen Bolt 11-16 (15-22)
Rear Roll Stopper 33-44 (45-60)
Rocker Arm Adjusting Screw Lock Nut 9-13 (12-18)
Rocker Arm Shaft Assembly Retaining Bolt 15-18 (20-25)
Sensor Wheel 9-11 (12-15)
Throttle Body-To-Intake Manifold Bolt 11-15 (15-20)
Timing Belt Tensioner Bolt 15-20 (20-27)
Transaxle Mount
Mounting Bolt 22-30 (30-40)
Through-Bolt 66-81 (90-110)
Water Pump Pulley Bolt 9-11 (12-15)
INCH Lbs. (N.m) 
Crankshaft Pulley-To-Sprocket Bolt 108-120 (12-14)
Oil Pan Bolt 53-71 (6-8)
Timing Belt Cover Bolt 89-106 (10-12)
Torque Converter-To-Drive Plate Bolt 84-120 (9-14)
Valve Cover Bolt 71-89 (8-10)
(1) Tighten in sequence. See Fig 1.
Fig 1: Tightening Sequence For Cylinder Head Bolts
G00008483Courtesy of HYUNDAI MOTOR CO.