FixVault
Home › Hyundai › 2004 › Accent Base › Repair and Diagnosis › Engine Performance › System › Engine Control System Diagnosis (2 Of 2) › DTC Troubleshooting Procedures › DTC P1765: Torque Reduction Signal - Malfunction › MONITOR Scan Tool DATA

MONITOR Scan Tool DATA

  1. Connect scan tool to Data Link Connector (DLC).
  2. Warm up the engine to normal operating temperature.
  3. Monitor DTC (Diagnostics Trouble Code) on the scan tool.
    Fig 1: Monitoring DTC (Diagnostics Trouble Code) On Scan Tool
    G03852072Courtesy of HYUNDAI MOTOR CO.
  4. Is the same DTC displayed again?

    YES 

    • Go to "W/HARNESS INSPECTION" procedure

    NO 

    • Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
About FixVault