FixVault
Home › Hyundai › 2004 › Elantra GLS, Standard › Repair and Diagnosis › External Pages › Different variant/trim › Section 1 (Automatic Transaxle System) › Automatic Transaxle System › Basic Inspection Adjustment › A/T Control Component Check › A/T Control Relay Check

A/T Control Relay Check

WARNING: This page is about a different variant/trim than selected.
  1. Remove the A/T control relay.
  2. Use jumper wires to connect A/T control relay terminal 2 to the battery (+) terminal and terminal 4 to the battery (-) terminal.
  3. Check the continuity between terminal (1) and terminal (3) of the A/T control relay when the jumper wires are connected to and disconnected from the battery.
  4. If there is a problem, replace the A/T control relay.
    Fig 1: A/T Control Relay Continuity Table
    G00747826Courtesy of HYUNDAI MOTOR CO.
    Fig 2: Checking A/T Control Relay
    G00747827Courtesy of HYUNDAI MOTOR CO.
About FixVault