Inspection Procedures

1. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

   Are all connectors good? 

Yes: Go to next

No: Repair or replace it.

1. Turn ignition switch to OFF position.
2. Check resistance of OTS between terminals 1 and 2 of the OTS connector.

Fig 1: Checking Resistance Of OTS Between Terminals 1 & 2 Of OTS Connector

Courtesy of HYUNDAI MOTOR CO.

• Refer to  SPECIFICATIONS   for more information. 

  Is resistance within specification? 

Yes: Proceed with ECM PROBLEM PROCEDURE  .

No: Replace OTS.