FixVault
Home › Hyundai › 2004 › XG350 Base › Repair and Diagnosis › Engine Performance › System › Engine Control System Diagnosis (2 Of 2) › Trouble Shooting For DTC › DTC P0460: Fuel Level Sensor Circuit › Inspection/Repair › Component Inspection

Component Inspection

  1. Ignition "OFF".
  2. Disconnect Fuel Level Sensor connector.
  3. Measure resistance between terminal "1" and "3" of the Fuel Level Sensor connector during lifting fuel float up and down (To Component Side).
    FLS SPECIFICATIONS

    FLS Normal Parameter
    Float position Full gauge 3/4 1/2 1/4 Empty gauge
    Resistance 8Ω 36Ω 66Ω 110Ω 200Ω
    Fuel volume 68l  52l  38l  23l  5l 
    Fig 1: Measuring Resistance Between Terminal 1 And 3 Of Fuel Level Sensor Connector
    G07374655
  4. Does the measured resistance of FLS change during lifting up and down the fuel level float?

    YES

    • Substitute with a known - good PCM and check for proper operation.

      If the problem is corrected, replace PCM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO

    • Substitute with a known - good Fuel Level Sensor and check for proper operation.

      If the problem is corrected, replace Fuel Level Sensor and go to "VERIFICATION OF VEHICLE REPAIR " procedure.

About FixVault