FixVault
Home › Hyundai › 2005 › Santa Fe LX, AWD › Repair and Diagnosis › Engine Performance › Engine Control Systems › Fuel System (G6CU-GSL 3.5) › Gasoline Engine Control System › Electric Throttle System (ETS) › Electronic Throttle System › Sensor Checking (Idle Switch) › Using Voltmeter

Using Voltmeter

  1. Disconnect the APS connector.
  2. Check the continuity between terminal 4 and sensor ground.
    APS SPECIFICATIONS

    TPS voltage Continuity
    Higher than 300~900mV Non-conductive (Infinity Ω)
    300~900mV Conductive (0Ω)
  3. If out of specification, replace the throttle position sensor.
    Fig 1: Checking Continuity Between Terminal 4 And Sensor Ground
    G03845325Courtesy of HYUNDAI MOTOR CO.
About FixVault